Highpoint RocketRAID 2320 User Manual download pdf (Page 64)

Step 5 Configure System to Mount Volumes during Startup

The system can be instructed to automatically mount the array(s) during startup by

modifying the file”/etc/fstab”.

For example, add the following line to tell the system to mount /dev/sda1 to location /

mnt/raid after startup:

/dev/sda1 /mnt/raid ext2 defaults 0 0

4 - Updating the Driver

To update the driver, simply reinstall the driver following the steps in previous

section, “ Install RocketRAID 2320 Driver on an Existing System “.

Note: If the driver is loaded in initrd (when system is installed onto a disk or array

attached to the RocketRAID 2320), you need to run the mkinitrd command to

update the initrd file. If you are using the lilo boot loader, run lilo again (# lilo).

5 - Uninstalling the Driver

To uninstall the RocketRAID 2320 driver

Note: The driver cannot be uninstalled while the system is booted from a disk or

array attached to the RocketRAID 2320.

To uninstall the driver, remove the lines added to /etc/modules.conf and /etc/fstab.

Linux Driver Support

5-14

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 76 77

No comments

Highpoint RocketRAID 2320 User Manual Page 64