Highpoint RocketRAID 2320 User Manual download pdf (Page 27)

2. In the popup window, select Hardware tab and then click Device Manager

button.

3. Double click the “SCSI and RAID controllers” entry. If the RocketRAID 2320

device entry is not displayed, or there are “?” or “!” marks displayed near the

RocketRAID 2320 entry, the driver has not been installed properly. Delete the

entries and reinstall the driver.

Installing the RocketRAID 2320 driver during a fresh Windows 2000/

XP/2003/x64 installation

1. After booting from the Windows 2000/XP/2003 CD-ROM, when the Windows

Setup blue screen appears, look towards the bottom of the screen. Windows will

prompt you to press the F6 key if you want to install a third party SCSI or RAID

driver. Press the F6 key at this time.

2. The setup procedure will continue, and will later instruct you to press the “S” key

to specify additional adapters. Press the “S” key as instructed.

3. Next, the setup program will prompt for the insertion of the driver diskette. Please

insert the driver diskette, and then press ENTER to continue.

4. The next window will display several driver options. Please select the

RocketRAID 2320 Controller for the corresponding operating system, and press

ENTER to continue.

1 - Installing the RAID Management Console/ Interface Overview

To install the RAID software, locate the setup.exe file located on the floppy diskette

labeled “DISK 1” (or the Disk 1 folder, if the software was downloaded). Double click

this file to start the Installation Wizard.

Note: If the system chassis supports SAF-TE, make sure to select the corresponding

chassis-type/manufacturer when prompted.

There is no need to restart the system after installing the software. To start the

software, click on the “Start” button, select “Programs”, and click on the “HPT

Management Console.”

RocketRAID 2320 Driver and Software Installation

4-5

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 76 77

No comments

Highpoint RocketRAID 2320 User Manual Page 27