Highpoint RocketHybrid 1222 User Manual download pdf (Page 11)



4. After installing the adapter, attach hard drives to the host adapter using the data cable. The

RocketHybrid 1220/1222 models utilize 2 SATA/eSATA cables, which are included in each retail box.

Each SATA cable can support a single SSD or HDD. Consult the chassis manual for proper

installation procedures.

Note: Many server-level chassis include hard-drive hot-swap bays. For these system chassis, cables

are attached to the chassis backplane, rather than directly to each individual hard drive. Consult the

chassis manual for proper installation procedures.

5. Close and secure the system chassis.

2.5 - Verifying Installation

Once the host adapter and hard drives have been installed into the chassis, boot-up the system to verify that

the hardware is properly recognized.

1. Power on the system. If the system detects the presence of the adapter, the RocketHybrid 1220/1222

BIOS Utility will be displayed during boot up.

2. Press Ctrl+M to access the RocketHybrid 1220/1222 adapter’s BIOS Utility.

The BIOS Utility will display information about hard drives attached to the adapter.

Make sure all attached drives are detected by this utility. If any of the hard drives are not detected, power

down the system and check the power and cable connections.

2.6 - Windows 7, 2008 and Vista – Native Driver support

The RocketHybrid 1220/1222 is natively support by the Windows 7, 2008 and Vista operating systems. It

will be recognized automatically, as an AHCI device. Driver installation is not required.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 42 43

No comments

Highpoint RocketHybrid 1222 User Manual Page 11